Posts made in October 6th, 2019

How you can Reduce Travertine Tile Around a Bullnose

Posted by on Oct 6, 2019 in Flooring | Comments Off on How you can Reduce Travertine Tile Around a Bullnose

Travertine is a organic stone quarried from about the globe and is recognized for its durability and elegance. It’s typically made use of in houses, hotels and buildings as an selection to marble. Travertine is installed as flooring and is also applied to create countertops and decorate walls. The rounded edge of bullnose tile provides a structured and completed appear when utilized for a backsplash or maybe a tiled baseboard.


  1. Mark the subfloor or substrate surface using a chalk line to make use of as a guide for laying the tiles. You don’t have to mark each and every square, just the perimeter.
  2. Set up an underlayment developed specifically for stone and marble floors. The material is made to help in waterproofing and vapor management also as to help the weight of travertine. Apply the underlayment according to the manufacturer’s directions.

3. Execute a dry test run to lay out the tiles and inspect them for defects. This can ensure you have every thing planned accordingly and will have the ability to complete the floor.

how to install bullnose corners

4. Cut the travertine tiles that may face the bullnose in line with your measurements using a wet saw. Give the cut tiles 24 hours to dry completely.

5. Mix the thinset in accordance with directions, and only mix sufficient to apply in one-half hour intervals to stop the thinset from drying out. Stir the thinset till it reaches a thick, peanut butter-like consistency.

6. Start off at the farthest corner, and use a notched trowel to apply the thinset for the substrate. Spread it out evenly over 1 section, using the straight edge with the trowel. Hold the trowel at a 45-degree angle, and comb the thinset over the initial section.

  1. Butter the back from the travertine tile together with the thinset, and lay it onto the substrate. Repeat the course of action of applying thinset to the substrate after which to the tiles for all remaining sections of how to install bullnose corners project. Clean up any mortar on the surface on the travertine or bullnose having a wet sponge.

8.Apply the grout in in between the travertine tiles at the same time as along the perimeter edge next to the bullnose tile. Clean any grout residue having a wet sponge. Use a pencil or the edge of a putty knife to clean mortar around the grout lines to keep the lines neat and uniform. Allow it to dry for 24 hours. The rounded edge of bullnose tile offers a structured and finished appear when made use of to get a backsplash or even a tiled baseboard.

Read More